
Before you specify
Frequently Asked Questions
What is the difference between the 240.1 S4 and the KOBRA 240 SS4?
The cut is identical — 1/8 inch strip, P-2, up to 26 sheets at 22 ft/min. The chassis is not. The 240.1 S4 has a 10.5 gallon bin against 9.5, a 4/5 HP motor against 3/4 HP, an automatic reverse system, a caster mounted cabinet and a bigger footprint at 16 x 14.4 x 25 inch and 53 lb, against 14.5 x 13 x 22 inch and 33 lb. Choose the 240.1 for a shared departmental machine, the 240 for a desk-side one.
Does it really never need oil?
KOBRA describes the 240.1 S4 as an oil-free system requiring no lubrication or maintenance. Strip-cut heads generate far less friction than cross-cut heads, which is why this is possible here and not on the C2 or C4. Adding oil anyway will not damage the machine, but it is not required and there is no reservoir to fill.
Can I leave staples and paper clips in the documents?
Yes. KOBRA specifies carbon hardened cutting knives unaffected by staples and clips. Ordinary staples and paper clips can stay. Binder clips, bulldog clips and ring binder mechanisms must come out — they are hardened steel and will chip the cutting teeth. Laminated sheets should also be kept out.
How many people can share it?
The combination of 26 sheets a pass, a 10.5 gallon bin and a continuous duty motor supports a department of roughly fifteen to thirty people doing normal office shredding. The motor is not the limit — there is no duty cycle — the bin and the queue are. If you need to serve a whole building, look at a larger office-centre machine with a wheelie bin rather than a cabinet.
Does it shred CDs?
Yes. The S4 is rated for CDs, DVDs and floppy disks as well as credit and chip cards. Feed discs individually rather than inside a stack of paper. If your only reason for choosing this model was disc destruction, note the cheaper KOBRA 240 SS4 carries the same rating.
What happens when it jams?
The 240.1 chassis has an automatic reverse system that senses the overload and backs the paper out without operator intervention. If a jam persists, switch to reverse manually, remove the wad, and feed a smaller stack. On a strip-cut machine at 26 sheets, persistent jamming almost always means overfeeding or damp paper rather than a fault.